Description
Dell 9W8C4 3.5" to 2.5" SAS/SATA Adapter Tray
The 9W8C4 is Dell's adapter tray for putting a 2.5-inch drive into a 3.5-inch bay. It accepts SAS or SATA drives, and Dell lists it against the PowerEdge T420. Plenty of older servers were built around large bays sized for mechanical disks. Fitting flash into one of those chassis means bridging the gap between the drive you want and the slot you actually have, and closing that gap is the entire job this part exists to do.
Key Features
- Adapts a single 2.5-inch drive to fit a 3.5-inch bay
- Takes SAS or SATA drives alike
- Listed by Dell against the PowerEdge T420
- Holds one drive per tray, so the count matches your drive count
- Supplied as the tray on its own, with no drive included
- Dell part number 9W8C4
Performance and Applications
A great many servers still earning their keep were specified with 3.5-inch bays and large spinning disks. Swapping those out for flash means buying 2.5-inch drives, because that's where the SSD market sits. One adapter per drive closes the gap, and you finish with a chassis full of quiet, quick storage without touching the backplane, the controller, or the cabling. Count the bays you plan to fill before ordering, since every drive going in needs an adapter of its own.
Compatibility and Installation
Match the tray to your server generation, because Dell has changed its designs across the PowerEdge range. The drive screws into the adapter first, then the whole assembly slides into the 3.5-inch bay until the latch drops. Confirm your controller takes the drive you're fitting as well, since the tray handles the mechanics and nothing beyond that.
Dell 9W8C4 Adapter Tray for Fitting SSDs into 3.5 Inch Bays
For a server built with large bays and a plan to fill them with flash, this is what bridges the two. One 2.5-inch SAS or SATA drive per tray, seated where the backplane can reach it.